Objectives:

This study aimed to evaluate the influence of surface pretreatment on the shear bond strength (SBS) of a resin luting cement to enamel and dentin with saliva contamination. The surface free energies (SFE) of the adherent surfaces were also determined.

Methods and Materials:

Bovine enamel and dentin were used in this study. For the saliva-contamination, human saliva was applied to the adherent surface for 60 seconds and then air-dried, and the specimens without saliva contamination served as controls. One group of contaminated surfaces was untreated (SC), and the others were pretreated with Katana Cleaner (KC), Multi Etchant (ME), or Ultra-Etch (UE). Fifteen specimens were prepared to measure the SBS for each test group.

The mixed resin luting cement paste was applied to the alumina-blasted surface of a stainless-steel rod and placed on the prepared tooth surface. The luting cement was light irradiated for 40 seconds. The bonded specimens were stored for 24 hours at 37°C and half of the bonded specimens underwent 10,000 thermal cycles. The SBS and SFE of the specimens after different pre-treatments were measured.

Results:

The two-way ANOVA revealed that the factors of pretreatment agent and storage condition had a significant effect on the SBS to enamel and dentin. The SFE values of the SC group were significantly lower than those of the other groups in both enamel and dentin. The SFE of pretreated surface was material dependent.

Conclusions:

A pretreatment agent containing functional monomers was shown to be effective in removing saliva contaminants and in creating an effective bonding surface for the resin luting cement.